FY2015 : From 1. April 2015 to 31. March 2016
Main activities in FY2015
|CO2 Emissions is under 3,254t and basic unit of production is under 30.0 t-CO2/hundred million yen, for preventing global warming
||Result of CO2 Emissions is 3,465t, so it was unachieved, but that of basic unit of production is 25.3, so it was achieved.
|Recycling rate of waste and valuables is over 99.9%
||Result is 100%. It achieves the target by separating waste thoroughly. And the survey of waste disposal site was done.
|Promoting local environmental activities
||Participating in periodical clean‐up campaign around the factory.
Aiming to reduction of environmental impact
Energy saving activity
Reduction of energy cost by replacing power receiving equipment
Improvement power loss by replacing power receiving equipment of energy saving type
【power reduction amount】
80 thousand khW/year
Clean-up campaign around the factory
Considering the life of the people around the factory, periodical clean‐up around the factory is done by us.
The date of implementation : 26. April 2014, 25. May 2015, 25. June 2015.
Emergency preparedness and response
Way of thinking and training program
As for the facilities, specified by environmental impact assessment, periodical simulator training is being done,
based on the operation standard.
And through this training, restudying whether the standard is need to be amend or not is done.
Test of emergency response procedure "Leakage of original solution"
- 1) Assuming the leakage of polyol from sending pipe at checking
- 2) Cutting the power supply of control panel off
- 3) Shutting emergency cut-off valve for supply pipe
- 4) Confirming the point of leakage
- 5) Transmitting the fact by reporting route
- 6) Confirming countermeasures for the point of leakage
- 7) Confirming effectiveness of procedures